STM32F407VET6 Mini

From STM32duino wiki
Jump to: navigation, search
Level of support Good
Flash 512KB
User LED(s) PB9 (lights when the pin is LOW)
User button(s) None
RTC Crystal Yes
ST-Link header Yes
Reset button Yes
USB Connector Yes. Micro USB - (good quality)
Access to Boot0 & Boot1 Yes. (DIL switches)
Additional features AT24C08 - 8K I2C EEPROM
Micro SD card connected to SDIO*
Manufacturer data

Hardware installation

Software installation

Where to buy

Ebay or AliExpress etc

Additional notes

  • SDIO interface is not supported at the time this wiki page was created.

Known issues

The board can have slightly incorrect value for USB pullup resistor. In case of issues enumerating the USB device check the pull-up resistor, the correct value should be 1.5k.

Other images